Fixed Assets Parameters

#1 Fixed Assets Parameters

top

The parameters of the Asset module are located in [Home>Parameters>Finance].

RIBBON BAR: the ribbon bar represents the form menu, that is the area in which the user can make actions related to the procedure in use. The list of the features is the following:

General
FunctionMeaning
Save ParametersIt enables the user to save the parameters set.
Cancel SettingsIt enables the user to cancel settings.
Parameters
FunctionMeaning
Verify PrecodeIf the flag is set, the precode must be predefined in the table and it cannot be freely set during the creation of the asset.
View AmountIf the flag is set, the amount is visible.
Default UMIt defines the Default UM if the previous flag is set.
Percentage on the Single AssetThe set flag activates a field, in the upper part of the asset, where you can set a depreciation percentage that is a prior percentage compared to the one set in the asset correspondent category.
Division ManagementIf the flag is set, you can assign, within the assets register, the division you need, otherwise the field is set by default.

BuildDate : 29 maggio 2013

Did you find this helpful?
Name 
Email 

Thank you for sending your feedback, the submitted information will be assigned to an internal operator, a notification email (if registered user) will be sent to you when your suggestion were applied.

There was an error processing your feedback information, make sure you provided the requested info.

© 2013 Fluentis Srl. All rights reserved.